Single Phase Cascaded Multilevel Inverter

SKU: PAN_LAB_039 Categories: ,



The Cascaded Multi Level Inverter setup provides wide range of research opportunity. The complete setup can be used for single phase MLI. In Single phase MLI scheme the maximum level will be 5 Level.

Basically, Inverter is a device that converts DC power to AC power at desired output voltage and frequency. Demerits of inverter are less efficiency, high cost, and high switching losses. To overcome these demerits, we are going to multilevel inverter. Various PWM Methods are as follows SPWM, PDPWM, PODPWM and APODPWM

1 in stock

Single Phase 3 Level Inverter Drive:


  • Consists of 4 Nos, 1200V, 50A. IGBT with proper heat sink and snubber circuit
  • 4 Nos high speed opto-isolator provided for IGBT PWM inverter.
  • 4 Nos IGBT gate driver IC provided for IGBT gate driving.
  • 5 Nos isolated +15v dc @ 0.5A capacity provided for control circuit diode bridge rectifier with capacitor provided for input AC-DC.
  • FRC connector provided for IGBT PWM input.
  • MCB protection for input power ON/OFF & protection.
  • One no of restart switch and LED provided for protection circuit indication & reset the unit.
  • One no of analog DC voltmeter provided for DC voltage measurement.
  • One no Power ON/OFF switch provided.
  • All are mounted on a nice cabinet with stickered front panel.
  • Test points provided for all parts of power circuit.

 DSP TMS320F2812 Development Board:


  • On Board XDS100 USB Emulator.
  • Device: TMS320F2812
  • ROM Memory Up to 128K x 16 ROM.
  • 150 MHz (6.67-ns Cycle Time).
  • 1K x 16 Each SARAM.
  • 25MHz on board crystal.
  • 12-Bit ADC, 16 Channels.
  • On board RS-232 connector with line driver.
  • SCIA or SCIB can configure single UART.
  • 8 Digital Inputs (Push Switch).
  • 4 Digital Inputs (Slide Switch).
  • 4 Analog Inputs (Trim pot).
  • 16×2 Numeric LCD.
  • 1 Buzzer.
  • 1 Relay.
  • 12-bit SPI DAC.
  • 3 Nos AC and DC Current Measurement Provision with signal conditioning system
  • 3 Nos AC and DC Voltage Measurement Provision with signal conditioning system

Power Supply and Load Specifications:

Power Supply:

  • Volt 230               V, 1Ph, 50Hz
  • Output                 Volt 50V
  • Output                 Current2A
  • Type                    Fixed Voltage

1Ph AC Induction Motor:

  • 0.5HP, 1Ph, 50Hz, 1400RPM Induction Motor

List of Experiments:

  • Single Phase Inverter: 3 Levels
  • Single Phase MLI: 5 Levels
  • 3 PWM Techniques for single phase.

List of Equipment’s:

  • 1 Phase 3 Level Inverter Drive:       1Nos
  • Digital Controller:                             1Nos
  • Power Supply:                                1Nos

Customer Reviews

There are no reviews yet.

Be the first to review “Single Phase Cascaded Multilevel Inverter”

This site uses Akismet to reduce spam. Learn how your comment data is processed.